MATLAB DISTRIBUTED COMPUTING SERVER 4 - SYSTEM ADMINISTRATORS GUIDE Manuel d'utilisateur télécharger pdf (Page 54)

3 Prod uct Installation

Step 1: Set Up Windows Cluster Hosts

If this is the first installation of MATLAB Distributed C omputing Server

on a cluster of W indow s m achines, you need to config ure these hosts for job

communications.

Note If you do not have a Windows cluster, or if you have already installed a

previous version of M AT L AB D istributed Computing Server on your W i n dows

cluster, you can skip this step and proceed to Step 2.

Configure Windows Firewalls. If you are using Windows firewalls on

your cluster nodes,

1 Log in as a user with administrator privileges.

2 Execute the following in a DOS command window.

matlabroot\toolbox\distcomp\bin\addMatlabToWindowsFirewall.bat

This command adds MATLAB as an allowed program. If you are using

other firewalls, you must configure them for similar accommodation.

Configure User Access to Installation. The user that mdce runs as

requires access to the cluster MATLAB in stallation location. By default, m dce

runs as the user

LocalSystem. If your network allows LocalSystem to access

the install location, you can proceed to the nex t step. (If you are not sure of

your network configuration and the access provided for

LocalSystem,contact

the MathWorks install support team.)

Note If Lo calSystem cannot access the install location, you must run mdce as

adifferentuser.

You can set a different user with these steps:

1 With any standard text editor (such as WordPad) open the mdce_def file

found at:

3-6

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 147 148

Pas de commentaire

MATLAB DISTRIBUTED COMPUTING SERVER 4 - SYSTEM ADMINISTRATORS GUIDE Manuel d'utilisateur Page 54