MATLAB EMBEDDED IDE LINK 4 - FOR USE WITH TEXAS INSTRUMENTS CODE COMPOSER STUDIO Guide de l'utilisateur télécharger pdf (Page 17)

Overview of Creating Models for Targeting

1-13

language compiler documentation. For a complete discussion of S-functions,

refer to your documentation about writing S-functions.

Note To build, load, and run code successfully on your target board,

MATLAB must be able to locate that board in your system configuration.

Make sure that the

Board Name in your Code Composer Studio setup and the

DSPBoardLabel in the Target Preference Block in your model match exactly.

During the same build operation, block parameter dialog entries are combined

into a project file for CCS for your TI C2000 board. If you selected the

Build

and execute

build action in the Target Preferences block, your makefile

invokes the TI cross-compiler to build an executable file that is automatically

downloaded via the parallel port to your target. After downloading the

executable file to the target, the build process runs the file on the board’s DSP.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 111 112

Pas de commentaire

MATLAB EMBEDDED IDE LINK 4 - FOR USE WITH TEXAS INSTRUMENTS CODE COMPOSER STUDIO Guide de l'utilisateur Page 17