MATLAB GAUGES BLOCKSET RELEASE NOTES Guide de l'utilisateur télécharger pdf (Page 21)

Working with a Model

1-15

Working with a Model

This section indicates how you can perform common tasks involving the model

you built in the section “Building the Model” on page 1-13. This section

includes:

•“Running the Simulation”

•“Saving the Model”

•“Printing the Model” on page 1-16

Running the Simulation

Run the simulation by choosing Start from the model window’s Simulation

menu. While the simulation is running, you can manipulate the needle of the

Generic Knob block and observe results on the Lower Right gauge block. This

figure shows the model after the needle of the Generic Knob block is moved

from its default position.

To stop the simulation, choose

Stop from the model window’s Simulation

menu.

Saving the Model

Save the model by choosing Save from the model window’s File menu. When

you save a model that contains blocks from the Dials & Gauges Blockset,

MATLAB automatically saves additional files that describe each Dials &

Gauges Blockset block. For example, if you save the model described in this

chapter with the name

sample, then MATLAB saves the following files.

sample.mdl

sample@Generic_Knob.ax

sample@Lower_Right.ax

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 113 114

Pas de commentaire

MATLAB GAUGES BLOCKSET RELEASE NOTES Guide de l'utilisateur Page 21