MATLAB GAUGES BLOCKSET RELEASE NOTES Guide de l'utilisateur télécharger pdf (Page 95)

Placing ActiveX Controls in a Figure Window

4-12

Note In case you accidentally close the figure window before you are finished

exploring the model, you can recreate it by executing dng_gaugewindow.

Saving and Reopening the Model

If you want to use this model in a different MATLAB session, then you must

preserve both the model and the MATLAB commands that create the figure

window and gauge. Here is an easy way to do this:

1 Save the model to give it a name.

2 If the model’s name is mymodel, then use these commands in MATLAB to

preserve the commands that create the figure window and gauge.

set_param('mymodel','PreLoadFcn','dng_gaugewindow');

save_system

Now, whenever you open mymodel, MATLAB automatically creates the figure

that contains the gauge.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 113 114

Pas de commentaire

MATLAB GAUGES BLOCKSET RELEASE NOTES Guide de l'utilisateur Page 95