MATLAB XPC TARGET 4 - IO Guide de l'utilisateur télécharger pdf (Page 19)

I/O Driver Blocks

2-9

4 Open a function group. For example, to open the A/D group for

ComputerBoards, double-click A/D, and then double-click

ComputerBoards.

A list with the A/D driver blocks for ComputerBoards opens.

5 From the block library, click-and-drag the name of an A/D board to the

Simulink block diagram. Likewise, click-and-drag the name of a D/A board

to your model

Simulink adds the new I/O blocks to your model.

6 Remove the signal generator block and add the analog input block in its

place. Remove the scope block and add the analog output block in its place.

The model

xpcosc should look like the figure shown below.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 181 182

Pas de commentaire

MATLAB XPC TARGET 4 - IO Guide de l'utilisateur Page 19