MATLAB XPC TARGET 4 - API GUIDE Guide de l'utilisateur télécharger pdf (Page 109)

100

101

Embedded Option Setup

4-11

For more detailed information about how to use the xPC Target Explorer

window, see “xPC Target Explorer” in Chapter 2 in the xPC Target getting

starting documentation.

Creating a DOS System Disk

When using DOSLoader mode or StandAlone mode, you must first boot your

target PC with DOS. These modes can be used from any boot device including

flash disk, 3.5 inch disk drive, or a hard disk drive.

In order to boot DOS with a target boot disk, a minimal DOS system is required

on the boot disk. With DOS, you can create a DOS boot disk using the command

sys A:

Note xPC Target Embedded Option does not include a DOS license. You

must obtain a valid DOS license for your target PC.

It is helpful to copy additional DOS utilities to the boot disk, including

• A DOS editor to edit files

• The format program to format a hard disk or flash memory

• The

fdisk program to create partitions

• The

sys program to transfer a DOS system onto another drive, such as the

hard disk drive

config.sys file is not necessary. The autoexec.bat file should be created to

boot the loader or a stand-alone xPC Target application automatically. This is

described in the following sections.

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 371 372

Commentaires sur ces manuels

Pas de commentaire

MATLAB XPC TARGET 4 - API GUIDE Guide de l'utilisateur Page 109

Commentaires sur ces manuels