MATLAB XPC TARGET 4 - API GUIDE Guide de l'utilisateur télécharger pdf (Page 302)

getxpcenv

14-58

TcpIpTargetISAMemPort

Value is '0xnnnn'.

If you are using an ISA bus Ethernet card, you

must enter values for the properties

TcpIpISAMemPort and TcpIpISAIRQ. The values

of these properties must correspond to the

jumper settings or ROM settings on your ISA

bus Ethernet card.

On your ISA bus card, assign an IRQ and I/O

port base address by moving the jumpers on the

card.

Set the I/O port base address to around 0x300.

If one of these hardware settings leads to a

conflict in your target PC, choose another I/O

port base address and make the corresponding

changes to your jumper settings.

TcpIpTargetISAIRQ

Value is 'n', where n is between 4 and 15.

If you are using an ISA bus Ethernet card, you

must enter values for the properties

TcpIpISAMemPort and TcpIpISAIRQ. The values

of these properties must correspond to the

jumper settings or ROM settings on the ISA-bus

Ethernet card.

On your ISA bus card, assign an IRQ and

I/O-port base address by moving the jumpers on

the card.

The MathWorks recommends setting the IRQ to

5, 10, or

11. If one of these hardware settings

leads to a conflict in your target PC, choose

another IRQ and make the corresponding

changes to your jumper settings.

Environment Property Description

1 2 ... 297 298 299 300 301 302 303 304 305 306 307 ... 371 372

Commentaires sur ces manuels

Pas de commentaire